FIRMWARE UPDATER
Update from the browser.
Start ADEPT in boot mode, connect USB, and select your firmware file. Follow each stage below while the updater prepares the flash, transfers the image, and waits for ADEPT to restart.
- Hold Blue + White while powering on ADEPT. Connect USB, then press Rescan. The device should appear as ADEPT Bootloader.
- Load the firmware image (.bin). The header is checked before anything is written.
- Press Update. Flash preparation takes about 80 seconds; the erase display shows elapsed time and an estimated countdown. Upload begins automatically. Keep USB and power connected through every stage.
LATEST
v1.70
v1.70
CONNECTION
USB (WEBMIDI SYSEX)
USB (WEBMIDI SYSEX)
BROWSER
CHROME / EDGE
CHROME / EDGE
DEVICE
Hold Blue + White during power-on, then connect USB and press RESCAN.
- 01ERASE
- 02UPLOAD
- 03VERIFY
- 04RESTART
Preparing update
IN PROGRESS0:00ELAPSED
KEEP USB AND POWER CONNECTED
Do not disconnect USB or power down during the update. Requires Chrome or Edge on desktop over HTTPS, with MIDI (SysEx) allowed for this site. If the bootloader does not appear, power up again holding BLUE + WHITE and press Rescan.